www.industry-asia-pacific.com

Aseptic PET Filling Line for Juices and Teas

Kamson Beverage installed a Sidel Aseptic Combi Predis line in Jiangsu, China, to fill juices, teas and protein drinks with frequent changeovers.

  www.sidel.com
Aseptic PET Filling Line for Juices and Teas

Kamson Beverage, part of the Mulanka Group, has expanded its aseptic beverage production in Jiangsu Province, China, with a Sidel Aseptic Combi Predis solution. The diversified group operates two beverage production sites in Jiangsu and focuses on brands for young consumers. The new line fills juices, tea, coffee, protein drinks and functional drinks.

Production Challenge
Consumer demand for healthier beverages, fresher taste, more variety and longer shelf life has led producers to increase the number of SKUs and shorten production runs. For an aseptic line, every additional changeover adds downtime and requires the sterile zone to be maintained reliably. Kamson needed medium-capacity equipment that could switch frequently between products and formats without compromising product safety.

Dry Preform Sterilisation Principle
Sidel Aseptic Combi Predis integrates dry preform sterilisation, stretch blow moulding, filling and capping in one system. Hydrogen peroxide (H2O2) is injected into the preforms before they enter the oven. The oven heat activates the sterilant, so the hot, sterile preforms move directly into the blow moulder. Because the container is sterilised at preform stage, the blow moulder and its parts do not need to be sterilised, and the process uses less chemicals and water than wet bottle sterilisation. Contactless filling further reduces the risk of recontamination.

Formats and Flexibility
The line handles bottle volumes from 200 ml to 1,500 ml in round, square and rectangular shapes, with 28 mm and 38 mm neck finishes. This range allows the same line to fill single-serve tea and protein drinks as well as larger juice formats.

Local Engineering and Validation
The solution was designed, manufactured and tested at Sidel's plant in Beijing, which has produced dry preform aseptic lines since the technology was localised in 2019. The site houses laboratories for aseptic validation and PET bottle performance testing. Kamson selected Sidel based on its experience in aseptic PET packaging.

Results
After installation at Kamson's site, the line passed aseptic validation on the first attempt. Since commissioning, Kamson has increased production capacity while gaining flexibility. Shorter changeover times and less downtime allow the company to respond faster to changes in production plans, while product protection and shelf-life performance are maintained. No figures were published. The improvement follows from the process design: when the blow moulder does not need to be sterilised, there are fewer steps to repeat at each changeover.

Edited by Evgeny Churilov, Induportals Media - Adapted by AI.

www.sidel.com

  Ask For More Information…

LinkedIn
Pinterest

Join the 155,000+ IMP followers